1. Materials:5 LEDs (1 orange, 2 yellow and 2 red) Note: If orange can not be obtained, yellow if fine. 4 Wheels, they can be from toy cars or rubb...

2. You will measure individual pieces of cardboard and cut them using an x-acto knife. All the dimensions will be posted belowName of part Length W...

3. This front of the car must remain separated from the back of the car Where the top stops, keep that separated from the back half as seen below G...

4. Use the straw you previously cut and glue it across the wheel cuts on the bottomPut a skewer through the straw, the wheel will go on the end of...

5. Put the skewer inside the straw with only one wheel onNext attach the other wheel and glue the skewer so the wheel can move but is still in place

6. You will need 5 LEDs and five 1k Ohm resistors in parallel. Make sure the headlights and siren are yellow and the taillights are red Follow the...

7. You will use 60/40 stranded wire to solder everything togetherMake sure nothing comes apart after you are finished, if the wires are not connect...

8. Put the circuit inside Mater complete with the yellow headlights and siren and red taillights. Cut a hole anywhere on the truck as a hole for th...

9. You should paint the entire body except for a few spots brownPainting the bottom is optional You should use burnt umber and then mix in orange a...

10. Next time we would add more electronic components and special features. For example, we could use a motor for the winch or a 555 timer for the...